Categories

DIY servo tester based on ATTiny85

Posted on Wednesday, June 19th, 2013 in DIY by DP

servotesterfront

Trandi made this simple  DIY Servo tester based on ATTiny85:

I had to test a RC speed controller that I wanted to use to control an electric car window motor, and for the 100th time I was facing the same dilemma: find 8 batteries for my remote control, dismount the RX part from the quadcopter and use that, OR grab the Arduino and write quickly some code to generate the corresponding signals? Neither of which was actually particularly handy…  So I finally decided to build a small stand alone servo tester.

This entry was posted on Wednesday, June 19th, 2013 at 7:00 pm and is filed under DIY. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • readybrek: Anyone got a any recommendations for a budget-priced hot air station?
  • William: lol I'm happy to waste 3c for each program/debug cycle... but probably not the time spent soldering a new device down to a proto board!...
  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...