Categories

ATX Breakout board free PCB build

Posted on Friday, May 31st, 2013 in builds by DP

IMAG1796

Gege built an ATX Breakout board free PCB.  The ATX breakout board routes the -12, 3.3, 5 and 12 volt ATX outputs to screw terminals, each protected by a 1.25 amp resettable polyfuse.

If you build a free PCB we’ll send you another one! Blog about it, post a picture on Flicker, whatever – we’ll send you a coupon code for the free PCB drawer.

Available for $13.80 at Seeed Studio.

This entry was posted on Friday, May 31st, 2013 at 11:00 am and is filed under builds. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

5 Responses to “ATX Breakout board free PCB build”

  1. Anders says:

    I wish these were still available in the free pcb drawer.

  2. CanaDave says:

    I bought one of these @ Seeed. A suggestion for improvement?…the screw post should have the little holes drilled in them so you can thread the wire through them instead of having to hook/wrap the wire around.

  3. GreggD says:

    I can’t find listed anywhere the size of the binding posts. I’d like to take one of these and replace the 3V3 and 12V with orange and yellow respectively, ala SATA power connectors. What color traditionally indicates -12V?

  4. Dan says:

    Any U.S. distributors for this?

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • DP.: fixed, thanks
  • Bovine: Title of article has the wrong number for ESP8266 typed.
  • burkm m: It drifting even further using that standard XO...
  • langwadt: a HC14 is a bad choice for an xtal oscillator, the unbuffered non-Schmitt trigger HCU04 is much better for that application
  • Bill F: I'm ready for one!