Resurrecting a WRT54G router with a launchpad

Posted on Wednesday, May 8th, 2013 in MSP430 by DP


Lalalandrus over at the 430h forum shares his experience  debricking a WRT54G router  with a MSP430 Launchpad:

I ported the code to a MSP430. Changing pinouts should be relatively straight forward in the DEFINES. . The router is fixed but took literally days, backing up the 128k CFE took three days even though I didnt need it. Wrtiting is a little faster at one-ish day.

Via 43oh.

This entry was posted on Wednesday, May 8th, 2013 at 11:15 am and is filed under MSP430. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

4 Responses to “Resurrecting a WRT54G router with a launchpad”

  1. Cde says:

    They changed the code, its a lot faster now (hours vs days)

  2. Crawford says:

    Umm. Pretty sure that’s WRT54G, not WRTG54 … (since I have a couple of them)

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • KH: Using an alkaline coin cell down to 1.0V or under is a very bad idea anyway, unless you as the designer or manufacturer don't care...
  • KH: Farnell says TS1001 is no longer stocked. Not on RS. Digikey says it's obsolete. That said, there are a lot of nanoamp-class parts on sale...
  • Peter: Sunday--
  • Chris Brightly: Best of luck to all, including the wayward prototypers yet to post!
  • Wolfi: o/