Categories

DIY wireless data transceiver

Posted on Thursday, April 25th, 2013 in DIY, wireless by DP

circuit

Build your own wireless transceiver:

Have you ever wanted to send data from a sensor or project wirelessly? This simple circuit allows you to build your own wireless transceiver using two ICs, a transistor, and two resistors. The IC is from Melexis and uses On-Off Keying modulation and can be battery powered.

Via Electronics Lab.

This entry was posted on Thursday, April 25th, 2013 at 9:00 pm and is filed under DIY, wireless. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

3 Responses to “DIY wireless data transceiver”

  1. Lars Berntzon says:

    Cool, but where is the receiver part?

  2. Mateusz says:

    Please go away… Silvershit product

  3. Denis says:

    Apparently Digikey has no idea what an MLX90125 is. It knows what the other one is

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • KH: TPS62200 will get him to under 15uA, a bit better than the 20-30uA he mentioned. I would try the same thing. Switch some resistors in...
  • KH: Yeah, it's an end-user thing. Very few people would spend hundreds of hours on this kind of project and sustain it. It's more or less...
  • Max: Not quite a dinosaur if you've seen Big Hero 6 though... wait. You've watched it with your kids, didn't you? That's cheating...! ;) One of...
  • Edward Mallon: A visiting researcher dropped by our humble basement workshop with questions about the physical skill level students would need if they added one of our...
  • KH: And that looks really expensive... Only browsed the vid though, I'm an dinosaur so I had the sound off too. Nice of him to open-source...