Categories

Tiny breakout board for 24LC512 EEPROM and MCP9802 temp sensor

Posted on Wednesday, March 6th, 2013 in measurement, PIC, sensors by the machinegeek

I2CBoard3
Raj I recently designed this tiny breakout board for Microchip’s 24LC512 EEPROM and MCP9802 temperature sensor devices, both of which support I2C protocol. This single board can be used for both sensing the ambient temperature and storing it.

You can view the circuit diagram and get more details on Raj’s Tindie project at EmbeddedLab.

Via the contact form.

This entry was posted on Wednesday, March 6th, 2013 at 12:01 am and is filed under measurement, PIC, sensors. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “Tiny breakout board for 24LC512 EEPROM and MCP9802 temp sensor”

  1. Drone says:

    Hey, nice. I was thinking about something like this but with a uSD card socket on it.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please