Categories

DIY remote control rocket launcher with Dangerous Prototypes stickers

Posted on Friday, February 22nd, 2013 in Free PCBs by DP

BDqndUbCIAACwGk-W600

Lonerganrob tweeted this picture of his DIY remote control rocket launcher with Dangerous Prototypes sticker attached to it.

good use for my free stickers its on my home made remote control rocket launcher :)

Three times a week we give away free PCBs,  and also a few stickers.   Feel free to share yours as well.

This entry was posted on Friday, February 22nd, 2013 at 3:00 pm and is filed under Free PCBs. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “DIY remote control rocket launcher with Dangerous Prototypes stickers”

  1. Even іf you’ve never done this type of work before, with the concise information they gave me during our phone conversation, it would be possible to do a complete check for the parts that require replacement. Transmissions. Before it really is put in, it ought to be cleaned with gasoline and kerosene initial and then spread with quality lubrication grease. Most cylindrical roller bearings are made of alloy steels or low-carbon steels. When we got back to the sales lot, I had my wife move the steering wheel from side to side, just enough to remove all the slack and a little bit more.

    Review my weblog – TIMKEN Spherical Roller Bearings

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • coppice: If all you have found so far is fake iphones, the next place you should visit is SEG in Hua Qiang Bei. Get out of...
  • Edward Cooper: Great article and good find on the markets! Any chance you can provide the locations of these places? I'm in Shenzhen at the moment and...
  • Dan: I'm up for one
  • TrickyNekro: Always in for another bunch! :-D
  • mol-1: Maybe this time !