Cheap laptop GPS module hacked to work with microcontrollers

Posted on Friday, January 25th, 2013 in hacks by DP

ublox pci-5s

Emeryth discovered that these cheap laptop PCI GPS modules can easily be interfaced with microcontrollers. On the back of the board there are testpoints which he identified as UART and USB. The USB is recognized as a CDC-ACM standard virtual COM port.

This entry was posted on Friday, January 25th, 2013 at 9:00 pm and is filed under hacks. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

11 Responses to “Cheap laptop GPS module hacked to work with microcontrollers”

  1. Alex says:

    Good hint.
    Now the question is, what (kind of) antenna to use for this device … anybody?

    • Emeryth says:

      According to the datasheet, any GPS antenna (active or passive) with a U.FL/IPEX connector should work.

      I bought some random $5 active antenna on ebay and it’s working, that’s all I have to say.

  2. Will Emite says:

    Any that use “Connection: Hirose U. FL – R”

  3. Looking at pictures of this module I’m thinking it might be possible to shear off the bottom half (the side with the PCI connector – there doesn’t appear to be any traces going on the area except for the PCI connection but I can’t see under the sticker.
    Can anyone who has one confirm that? I just bought one to check, if so it would be a nice size for use in a project as well (not that it is too big to begin with for most projects).
    Awesome tip Emeryth – thanks!

    • Emeryth says:

      I think it is possible to cut it in half, there is a half-sized version of the card in the ublox product catalog.
      There is nothing under the sticker except a fancy ublox logo made out of copper.
      Although the PCB has more than two layers, so you can’t really see where the traces are going.

      • Cool, thanks for checking – I’ll give it a try when mine comes and see what happens.
        Looking at a some mini-pci-e pinouts it looks like perhaps Pin 17 and pin 19 (or maybe 11 and 13?) might be Rx and Tx (seems to vary by board though) and that 36 and 38 should be USB -/+ for sure. In case someone wanted to make a clean breakout board – personally I plan to cut it in half and solder to the points you identified though.

  4. Bob says:

    By the time you have got an antenna as well this is going to cost the same as just getting a USB receiver!

  5. rm says:

    One would hope an author who posts in a blog like this would know difference between “PCI” and “Mini PCI-E“.

  6. Anupama says:

    Can it be found on Eagle?

    Thank you

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Nathan Johnson: 100 channels. Not many are legal in any given area. Be sure to comply with local laws.
  • William Brodie-Tyrrell: It's getting to the point where it's cheaper and definitely easier to use a Pi Zero or similar and a $20 3G USB dongle. Power...
  • KH: IIRC most of the actual operating system of modern HDDs is in one of the platter(s); the stuff on the 25VF010 is a bootup firmware......
  • Trev: I don't know of any inexpensive 3G modules (prices start around $US 50), but it does explain why 2G modules are relatively inexpensive by comparison....
  • Zonie: This site Rocks!