Categories

LED sign control board replaced with Arduino

Posted on Wednesday, January 9th, 2013 in LEDs, repair, tutorials by DP

Signature-Electronic-Signs-Hack-and-Repair

Bob picked up a huge LED matrix sign on eBay that has power supply problems. After fixing the power supply, he decided to replace the controler boards with an Arduino.

Via Hacked Gadgets.

This entry was posted on Wednesday, January 9th, 2013 at 1:00 pm and is filed under LEDs, repair, tutorials. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “LED sign control board replaced with Arduino”

  1. tecnoblish says:

    i want a thing like that… how much it is??

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • KH: TPS62200 will get him to under 15uA, a bit better than the 20-30uA he mentioned. I would try the same thing. Switch some resistors in...
  • KH: Yeah, it's an end-user thing. Very few people would spend hundreds of hours on this kind of project and sustain it. It's more or less...
  • Max: Not quite a dinosaur if you've seen Big Hero 6 though... wait. You've watched it with your kids, didn't you? That's cheating...! ;) One of...
  • Edward Mallon: A visiting researcher dropped by our humble basement workshop with questions about the physical skill level students would need if they added one of our...
  • KH: And that looks really expensive... Only browsed the vid though, I'm an dinosaur so I had the sound off too. Nice of him to open-source...