Categories

ATX Breakout board free PCB build

Posted on Wednesday, January 2nd, 2013 in builds by DP

IMG_6166-W600

Cosminnci built an ATX Breakout board v1.0 free PCB.  The ATX breakout board routes the -12, 3.3, 5 and 12 volt ATX outputs to screw terminals, each protected by a 1.25 amp resettable polyfuse.

If you build a free PCB we’ll send you another one! Blog about it, post a picture on Flicker, whatever – we’ll send you a coupon code for the free PCB drawer.

Available for $13.80 at Seeed Studio.

This entry was posted on Wednesday, January 2nd, 2013 at 11:45 am and is filed under builds. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “ATX Breakout board free PCB build”

  1. Anders says:

    I wish the atx breakout board was still available in the fre pcb drawer.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • KH: After reading all the comments, I have questions: Does this mean STM32 and AVR boards/parts from dodgy online sellers are suspect? What are your opinions?...
  • Sjaak: They are available with more flash then their ST counterparts which makes them more interesting. You don't have to port the code, but use another...
  • Sjaak: I dunno if you can 'license' register definitions, but I'm not a lawyer. Since the chip is available since 2015 and I haven't heard of...
  • Sjaak: They can be found on taobao or the Chinese markets in Shenzhen.
  • KH: I've been a really good boy, I only buy MCU parts from RS and Farnell. :-)