Categories

Paddle Clock free PCB build

Posted on Wednesday, December 26th, 2012 in builds by DP

A-47Y0qCEAAFjTH

Faultykyle built one module of the Paddle Clock, a clock kit project we worked on several years ago. The board consists of two 7-segment displays driven via tw0 ‘595 serial to parallel shift registers. The control and serial signals are routed to a PCB edge connecter, which was intended to to plug into the Paddle Clock base.

If you build a free PCB we’ll send you another one! Blog about it, post a picture on Flicker, whatever – we’ll send you a coupon code for the free PCB drawer.

This entry was posted on Wednesday, December 26th, 2012 at 5:00 pm and is filed under builds. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

2 Responses to “Paddle Clock free PCB build”

  1. Sleepwalker3 says:

    Spammer

  2. vimark says:

    These are the early DP protos

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Bob: Jambalaya rocks.
  • KH: I should point out something... well, lead acid car batteries are designed to be well-charged all the time. The plates (which are patterned and thin)...
  • David Haile: You are a smart person and absolutely correct. That kind of current needs a lead acid car battery behind it. Still, it does have its...
  • KH: The solution discussed in the linked article is wrong. It's a largish Lipo (2500mAh) and he thinks 77uA is acceptable... ha ha ha ha ha....
  • Dave: I never had to opportunity to learn or use this stuff when I was in college (I'm sooo old that op-amps were just being developed...