Categories

GOduino III – the breadboard-friendly Arduino-based robot controller

Posted on Friday, November 16th, 2012 in Arduino by DP

Techbitar wrote this Instructable detailing the build of his GOduino III – the breadboard-friendly Arduino-based robot controller. We previously covered the GOduino II.

The GOduino III is based on the ATmega328p microcontroller and the L293D dual h-bridge. It’s built with DIP ICs and through-hole components for ease of assembly and repair.  This robot controller can handle 2 small servos and 2 DC brushed motors (max 1.2A for each motor with 2 X L293D).

Via Instructables.

This entry was posted on Friday, November 16th, 2012 at 4:00 pm and is filed under Arduino. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Drone: Gee, just the sight of one of these HP493A TWT laboratory amps brings back decades-old memories. There are four models covering 1-12.4 GHz in steps...
  • KH: After reading all the comments, I have questions: Does this mean STM32 and AVR boards/parts from dodgy online sellers are suspect? What are your opinions?...
  • Sjaak: They are available with more flash then their ST counterparts which makes them more interesting. You don't have to port the code, but use another...
  • Sjaak: I dunno if you can 'license' register definitions, but I'm not a lawyer. Since the chip is available since 2015 and I haven't heard of...
  • Sjaak: They can be found on taobao or the Chinese markets in Shenzhen.