Categories

555 based PWM generator free-form wire style

Posted on Tuesday, November 6th, 2012 in DIY by DP

Another cool free-from wire circuit. Jeff designed this 555 based PWM generator in Eagle. He printed the trace layer and used it as a template for bending the wires.

I built this 3D, freeform circuit as a test project. I’ve seen a few lately and love the way they look, and after making this circuit, I’m excited about this method as an alternative to point-to-point soldering or etching for small, one-off boards.

Check out a video of his design process below.

This entry was posted on Tuesday, November 6th, 2012 at 7:00 pm and is filed under DIY. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Dave B: Got two of them. If you let the battery run flat, they don't charge! You have to pull the battery, and get enough charge in...
  • Bill F: My turn?
  • Chris: Ok!
  • Bob: Free PCB for me!
  • Blars: Yet another meaningless comment.