Categories

ATX Breakout board free PCB build

Posted on Friday, September 7th, 2012 in builds by DP

Dolabra built an ATX Breakout board free PCB. The ATX breakout board routes the -12, 3.3, 5 and 12 volt ATX outputs to screw terminals, each protected by a 1.25 amp resettable polyfuse.

It wouldn’t be a free build if something wasn’t bodged together. In my case it was the ATX connector. I got all the parts from ebay — I couldn’t find a right angle ATX connector on ebay, so I got a vertical one. I thought it would fit, but it didn’t. So I ended up making it a right angle by bending the bottom row of pins and extending the top row of pins with 18ga finishing nails! It actually worked better than I expected. Also the push button I got from ebay was smaller than the footprint, but I was able to make it fit. The downside of buying from ebay.

If you build a free PCB we’ll send you another one! Blog about it, post a picture on Flicker, whatever – we’ll send you a coupon code for the free PCB drawer.

Available for $13.80 at Seeed Studio.

Via the forum.

This entry was posted on Friday, September 7th, 2012 at 9:00 pm and is filed under builds. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joshua: Will be put to good use
  • Brett: free
  • ALeggeUp: First try
  • DrObscure: Me three..
  • IWAN NAWI: PCB Sunday, right here on the blog . http://dangerousprototypes.com/blog/2016/08/28/free-pcb-sunday-pick-your-pcb-264/