Categories

FT311D Android Open Accessory IC breakout board update

Posted on Thursday, August 16th, 2012 in Prototypes, releases by DP

Here’s the update in our earlier PROTOTYPE PREVIEW: FT311D Android Open Accessory IC breakout board post:

  • Added 2 10k pullup resistors on IOBUS0 and IOBUS1 with series jumper to turn it on/off
  • Change 1×8 header to 2×5 for the breakout IO BUSES
  • Breakout 3v3 and 5v onto the 2×5 IO BUSES header too
  • Moved vias away from the labels on IOBUS5 GND, 3v3 and 5v

Thanks for your suggestions, and comments.

 

This entry was posted on Thursday, August 16th, 2012 at 7:00 pm and is filed under Prototypes, releases. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

2 Responses to “FT311D Android Open Accessory IC breakout board update”

  1. saeid aryan says:

    Hello, may you send me PCB & schematics of this FT311D module files?
    Thanks.

  2. jorge says:

    may you send me PCB & schematics of this FT311D module files?

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • KH: So Romanians use old ICs too, a bit reminiscent of Dilshan's projects. I'm vaguely disappointed by the liberal use of float data and float calculations....
  • Max: This is of course no "0-30V" supply - the single-supply standard LM723 schematic can't go all the way down to zero, which is why I...
  • KH: A power-off current draw of 4mA for the Sony A6000 is a defect, product recall territory. It hits the camera battery with unacceptable wear and...
  • Olav Storstrøm: Please add 9-pin D-sub RJ45 and RJ12 connectors! Thanks!
  • KH: Hydroponics is like home automation. Every year you have folks who start projects like these and think it will take off and become a big...