Categories

PIC12F source shared for the one-wire HD44780 LCD controller

Posted on Friday, July 27th, 2012 in LCD, PIC by DP

As a follow up to the “One wire control of HD44780 LCDs” post, McLaren shared the Assembly source code for his project. Pick up the source in the forum.

Assembly language source file and hex file (for 12F683) attached… Allow approximately 60 msecs after power-up for LCD initialization before sending commands and/or data to the LCD. Default 57600 baud (can be changed in the firmware).

Via the forum.

This entry was posted on Friday, July 27th, 2012 at 7:00 pm and is filed under LCD, PIC. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

5 Responses to “PIC12F source shared for the one-wire HD44780 LCD controller”

  1. Nexus says:

    forum link broken

  2. FourthDr says:

    What dev board is that? And, yup link is broken. Can’t find the forum message in a search either.

  3. Lynn says:

    Fixed, thanks!

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Alan: Reminds me of "bug zappers" shaped like tennis racquet. Outer mesh is ground for human contact, inner mesh has high voltage. They typically run from...
  • KH: He had qualms about electrolytic cap leakage impacting sleep current. I think such leakage is very low and hard to measure using hobby equipment, so...
  • Mike: Love these! great source for makers!
  • KH: Is my eyes playing tricks on me or did he just use gobs and gobs of solder on the top side?
  • Doug: When do we find out the winner??