Categories

GOduino II motor driver

Posted on Tuesday, April 10th, 2012 in Arduino, robotics by the machinegeek


Hazim Bitar writes in about the GOduino II motor driver project. In addition to the Atmega328p w/Opti bootloader, he uses a L293D h-bridge and various supporting caps and resistors giving the project a total estimated cost of about $20.

Visit the TechBitar blog for project build details, along with schematic and Arduino sketch.

Via the contact form.

This entry was posted on Tuesday, April 10th, 2012 at 5:49 pm and is filed under Arduino, robotics. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Pekka Akselin: This is ridiculous!? :-) We are back at 256(!) byte EPROMs that needed multiple, a handful, of voltages to run! :-(
  • KH: Let's try a back-of-envelope calc balancing energies. From MCP1700 datasheet, there are graphs for a 200mA load step. Estimate the energy shortfall as 12uJ. Say...
  • Daniel: It's been a week and my comment is still awaiting moderation. Apparently the CIA doesn't want their involvement known?
  • KH: Agree, so okay, I guess he must have learned from somewhere. 100nF and 1000uF is so far apart, that was jarring; it's more magic incantation...
  • Max: I have a suspicion the hefty electrolytic cap might be some sort of cargo cult carry-over from other RF-based projects - for instance, I've seen...