Categories

Measuring temperature with Duinomite and KTY81

Posted on Saturday, January 21st, 2012 in Arduino, measurement by the machinegeek

Olimex has posted this project for measuring temperature in range -55+150C for a solar water heater system. It uses the KTY81/110, a low cost PTC thermistor from NXP. The MCU board is the Duinomite we features in a previous post.

Via the contact form.

This entry was posted on Saturday, January 21st, 2012 at 12:47 am and is filed under Arduino, measurement. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • coppice: If all you have found so far is fake iphones, the next place you should visit is SEG in Hua Qiang Bei. Get out of...
  • Edward Cooper: Great article and good find on the markets! Any chance you can provide the locations of these places? I'm in Shenzhen at the moment and...
  • Dan: I'm up for one
  • TrickyNekro: Always in for another bunch! :-D
  • mol-1: Maybe this time !