Categories

DIY PIC16F883 breakout board

Posted on Tuesday, December 20th, 2011 in dev boards, DIY by Arup
DIY PIC16F883 Development Board

Phil made a DIY breakout board for the PIC16F883 microcontroller. The board uses a surface-mount single-layer design, and the parts are nicely spaced.  It’s an easy board to make at home using the DIY toner-transfer method of PCB etching. You can download the source files and other design data from his site.

Via Jumperone.

This entry was posted on Tuesday, December 20th, 2011 at 1:00 pm and is filed under dev boards, DIY. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “DIY PIC16F883 breakout board”

  1. Rohit de Sa says:

    Excellent soldering. And the parts placement looks like its done by machine, not hand….great job! *bows down*
    :-)

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Edward Fung: I love this offer!!!
  • Edward Mallon: I managed to get oversampling working well on cheap Arduino promini clones. Turns out all you have to do is toggle a digital pin connected...
  • TrickyNekro: A bit late for the dance but hey! I can always try!
  • Rene Jams: the basic idea is good - a neg feedback opposed to signal ground the datasheet noise density - https://datasheets.maximintegrated.com/en/ds/MAX4238-MAX4239.pdf (fig. - DC to 10kHz NOISE...
  • Geoff: Yes pleeease