Categories

7400 competition entry: Etch-a-Sketch toy

Posted on Friday, October 21st, 2011 in 7400 contest by DP

Daniel entered an Electronic realization of Etch-A-Sketch toy into the Open 7400 Logic Competition:

This project is an electronic realization of the famous Ohio Arts “Etch-A-Sketch” toy, with a twist.  Like the original, two rotary knobs are used to move a cursor horizontally and vertically, respectively, but unlike the original, a third knob selects one of 32 different sketch pages.  Simple flip-pad animations can therefore be created by twirling the page knob rapidly.

Via the contact form.

This entry was posted on Friday, October 21st, 2011 at 3:00 pm and is filed under 7400 contest. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “7400 competition entry: Etch-a-Sketch toy”

  1. Dave says:

    This one looks like the best so far. It’s got it all: an original concept, fully realized and working, with impressive functionality, demonstrating and using the richness of the 74XX series. I haven’t seen another entry in the contest that comes close! This should be made into a kit!

    Dave

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Edward Mallon: A teacher friend asked us for faster build that was less dependent on soldering because they didn't have the budget for that kit. So we've...
  • lostengineer: hahaha an entire article just saying to heat-shrink your wires or glue them if they might move around a lot. When did common sense die?
  • readybrek: They're tasty tasty very very tasty... they're very tasty.
  • hli: Sunday++
  • Chamod: Check on your buddy. Make sure they don't forget their lunchbox.