Categories

Verilog model for 24xx1025 EEPROM released

Posted on Tuesday, May 31st, 2011 in software by Ian

octal writes:

Microchip released the Verilog model for 24xx1025 Devices :)
a good learning experience

Via the forum.

This entry was posted on Tuesday, May 31st, 2011 at 10:04 pm and is filed under software. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “Verilog model for 24xx1025 EEPROM released”

  1. tony says:

    thank’s

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please