Categories

Single-sided, through-hole USB IR Toy v2

Posted on Friday, May 27th, 2011 in Infrared toy by Ian

LisandroP made a  single-sided PCB version of the USB IR Toy v2:

I’ve recently built a single-sided, through-hole version of the USB IR Toy v2, using the schematic posted on the wiki for it without the pin breakout area…

Mine is 40x50mm using an USB-A connector and includes a USB pin header, VCC/GND/RX/TX header for serial communications and ICSP – had to dispense with the pin breakout area though.

gSchem and PCB formatted design files are posted.

Via the forum.

This entry was posted on Friday, May 27th, 2011 at 9:00 am and is filed under Infrared toy. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “Single-sided, through-hole USB IR Toy v2”

  1. rsdio says:

    Awesome work!

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • readybrek: Anyone got a any recommendations for a budget-priced hot air station?
  • William: lol I'm happy to waste 3c for each program/debug cycle... but probably not the time spent soldering a new device down to a proto board!...
  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...