3D printable IDC header shrouds

Posted on Wednesday, April 6th, 2011 in 3D fabrication by NicholasCLewis

Renosis has created a 3D printable add-on shroud for 6 and 10 pin IDC headers.  Breakaway headers are much cheaper than shrouded headers and it would be possible to make them in other sizes if needed.

If you have access to a 3D printer this looks like a great way to add shrouds to your projects.  You could also use this trick to add a shroud to your Bus Pirate.

Get your own handy Bus Pirate for $30, including world-wide shipping. Also available from our friendly distributors.

This entry was posted on Wednesday, April 6th, 2011 at 12:57 pm and is filed under 3D fabrication. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

2 Responses to “3D printable IDC header shrouds”

  1. Jason Alderman says:

    3D printing is great and all, but this seems like a lot of trouble to save less than $1:

    A custom enclosure for that board would be a great use of the printer!

  2. DJUltis says:

    The cost to print one is a fraction of the cost, and no more waiting for shipping!

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Nathan Johnson: 100 channels. Not many are legal in any given area. Be sure to comply with local laws.
  • William Brodie-Tyrrell: It's getting to the point where it's cheaper and definitely easier to use a Pi Zero or similar and a $20 3G USB dongle. Power...
  • KH: IIRC most of the actual operating system of modern HDDs is in one of the platter(s); the stuff on the 25VF010 is a bootup firmware......
  • Trev: I don't know of any inexpensive 3G modules (prices start around $US 50), but it does explain why 2G modules are relatively inexpensive by comparison....
  • Zonie: This site Rocks!