Categories

Arduino magnetic levitation project

Posted on Tuesday, February 15th, 2011 in Arduino, code, how-to by the machinegeek

mekonik has published complete details on his Arduino magnetic levitation project. Not content to settle for a typical “hello world” LED blinker as his first project, he supplemented the Arduino with an electromagnet, Honeywell SS19 Hall effect sensor, MC3401P op amp, NPN transistor and 1N4001 rectifier. The circuit essentially uses the small Hall effect sensor to sense the field of the permanent magnet and uses that information calculated by the Arduino to control the modulation of the magnetic field of the electromagnet. Pretty cool!

More photos and Arduino source code are available.

This entry was posted on Tuesday, February 15th, 2011 at 11:26 pm and is filed under Arduino, code, how-to. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

3 Responses to “Arduino magnetic levitation project”

  1. Zanardo says:

    Very nice!!!

    Congratulations :)

  2. voidptr says:

    that is cool !

  3. S. Rogers says:

    Can you re-upload the code, please?

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • coppice: If all you have found so far is fake iphones, the next place you should visit is SEG in Hua Qiang Bei. Get out of...
  • Edward Cooper: Great article and good find on the markets! Any chance you can provide the locations of these places? I'm in Shenzhen at the moment and...
  • Dan: I'm up for one
  • TrickyNekro: Always in for another bunch! :-D
  • mol-1: Maybe this time !