Categories

Bus Pirate and FSA03 GPS how-to

Posted on Saturday, April 3rd, 2010 in Bus Pirate by Ian

Ril3y shows how to use a FSA03 GPS with the Bus Pirate:

I have a few projects that I would like to include GPS data in, in the near future.  So I went ahead and picked up a nice ublox based GPS.  You can get it here:  I wanted to used it right away.  So rather than coding up some AVR C or arduino stuff I decided to use my bus pirate for the job.  Here is the settings I used to get it up and going…

The case in the picture is one of Ril3y’s laser-etched Bus Pirate cases, more about that here.

This entry was posted on Saturday, April 3rd, 2010 at 7:36 am and is filed under Bus Pirate. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please