Categories

Binary mode, AUX pin updates

Posted on Friday, October 30th, 2009 in binmode, Bus Pirate by Ian

rawspi

There’s a new Bus Pirate v2.9 nightly that adds several small features and improvements. The primary binary mode now has commands to access the voltage probe and setup pulse-width modulation on the AUX pin. Binmode documentation is updated with these new commands. We also improved the code behind the frequency generator and frequency measurement features in user mode.

This entry was posted on Friday, October 30th, 2009 at 7:27 am and is filed under binmode, Bus Pirate. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Edward Mallon: Like a great Hollywood franchise, I've finally put together the prequel - months after the I2C registers tutorial was released: https://edwardmallon.wordpress.com/2017/12/17/adding-sensors-to-an-arduino-data-logger/ This adds to the...
  • Drone: So these go for around $330 USD and NO published calibration procedure online or otherwise? Given what's inside - I don't think I'll be considering...
  • Pekka Akselin: This is ridiculous!? :-) We are back at 256(!) byte EPROMs that needed multiple, a handful, of voltages to run! :-(
  • KH: Let's try a back-of-envelope calc balancing energies. From MCP1700 datasheet, there are graphs for a 200mA load step. Estimate the energy shortfall as 12uJ. Say...
  • Daniel: It's been a week and my comment is still awaiting moderation. Apparently the CIA doesn't want their involvement known?