It’s finally here! The Bus Blaster v2 JTAG debugger is now in stock and shipping at Seeed Studio. Read the full hardware design article There’s a ton of JTAG debuggers out there, what makes the Bus Blaster v2 so special? V2 has a reprogrammable logic chip (CPLD) that sits between the FT2232H USB chip and […]
Tag Archives: Bus Blaster v2
Week in (p)review: March 25, 2011
Don’t forget to share your current project in the comments or the forum. This week our favorite project gets a free QFP protoboard. Here’s a summary of major developments over the last week: Bus Blaster v2 was featured in this week’s status update post, the hardware is being tested now and the documentation is mostly […]
Bus Blaster v2: JTAG Serial Wire Debug support
A KT-link buffer clone supporting JTAG Serial Wire Debug is now available for Bus Blaster v2 pre-release testers. This should support the new 2-wire SWD debugging protocol when available in OpenOCD and urJTAG. The KT-link is the first FT2232-based JTAG debugger with support for the new SWD and SWV JTAG interface used on low pin […]