Categories

Improving the HC-SR04 ultrasonic sensor

Posted on Sunday, March 16th, 2014 in sensors by the machinegeek
This entry was posted on Sunday, March 16th, 2014 at 12:01 am and is filed under sensors. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “Improving the HC-SR04 ultrasonic sensor”

  1. riyan purewal says:

    hi i am trying to make the hexbug baby spider
    please tell me what all do i need.
    thanks in advanced

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please