Categories

Teardown: Teledyne LeCroy HDO4024 12-Bit oscilloscope

Posted on Monday, October 7th, 2013 in oscilloscope, Teardowns by the machinegeek


Sebastian voided his warranty and bravely went where others fear to tread, dissecting the Teledyne LeCroy HDO4024 12-Bit oscilloscope. He produced this post detailing his findings.

Via the contact form.

This entry was posted on Monday, October 7th, 2013 at 3:42 am and is filed under oscilloscope, Teardowns. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “Teardown: Teledyne LeCroy HDO4024 12-Bit oscilloscope”

  1. dgreig says:

    Well you have larger wobbly bits than I, must be size of planets.
    Which brand and model of front end and cal relay? Aha, Omron. A picture is worth!
    Any idea of which FPGA’s, the JTAG connector might give it away, but there again pehaps not, I usually make flex adaptors for most projects nowadays. The SPI flash might be a clue.

    Be interesting to see what might be lurking on the I2C and SPI buses.
    The interesting thing is the lack or perhaps differing solder resist on the diff traces.
    Channel to channel isolation, or lack of hence harmonics, may well be due to “safety standards “. Have only seen Agilent with decent channel isolation. There again there is also the possibility of DSP compromise.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • coppice: If all you have found so far is fake iphones, the next place you should visit is SEG in Hua Qiang Bei. Get out of...
  • Edward Cooper: Great article and good find on the markets! Any chance you can provide the locations of these places? I'm in Shenzhen at the moment and...
  • Dan: I'm up for one
  • TrickyNekro: Always in for another bunch! :-D
  • mol-1: Maybe this time !