Categories

Homebrew SMT stencil

Posted on Monday, April 22nd, 2013 in skills, techniques by the machinegeek

article_stencil_Image20
Andre shares this short article on how to make homebrew solder paste stencils from 0.1mm brass plates.

Via the contact form.

This entry was posted on Monday, April 22nd, 2013 at 4:00 pm and is filed under skills, techniques. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please