Categories

DCC 2012: FlexRadio and SDR architecture

Posted on Tuesday, December 4th, 2012 in RF, SDR, talks by the machinegeek


At the 31th Annual ARRL and TAPR Digital Communications Conference held last September in Atlanta, GA, FlexRadio VP Stephen Hicks N5AC gives an in depth presentation on SDR and its potential. He outlines his company’s new Flex 6000 series, a Linux based commercial product based on components used in government radios. While this is not an open source project, it’s still an interesting presentation on SDR from the commercial perspective.

Darryl via the contact form.

This entry was posted on Tuesday, December 4th, 2012 at 4:00 pm and is filed under RF, SDR, talks. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

3 Responses to “DCC 2012: FlexRadio and SDR architecture”

  1. Avishay says:

    Is there a link to the presentation?

  2. Drone says:

    These FlexRadio Boxes are outrageously priced IMHO (only).

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Edward Mallon: A teacher friend asked us for faster build that was less dependent on soldering because they didn't have the budget for that kit. So we've...
  • lostengineer: hahaha an entire article just saying to heat-shrink your wires or glue them if they might move around a lot. When did common sense die?
  • readybrek: They're tasty tasty very very tasty... they're very tasty.
  • hli: Sunday++
  • Chamod: Check on your buddy. Make sure they don't forget their lunchbox.