Categories

UV lightbox for PCB making

Posted on Tuesday, November 27th, 2012 in DIY, LEDs, PCBs by the machinegeek


Dieter Oelofse built this UV light box for making PCBs and wrote a detailed explanation describing the build. “I needed something that could illuminate a board from both the top and bottom simultaniously, in order to avoid complex re-allignment of the top and bottom layers in between exposures. Secondly, it need to fit on my desk, since working in the garage is a pain. So I settled on a box built from MDF from the local hardware store and UV LEDs.”

Via the contact form.

This entry was posted on Tuesday, November 27th, 2012 at 11:38 pm and is filed under DIY, LEDs, PCBs. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • KH: A power-off current draw of 4mA for the Sony A6000 is a defect, product recall territory. It hits the camera battery with unacceptable wear and...
  • KH: Hydroponics is like home automation. Every year you have folks who start projects like these and think it will take off and become a big...
  • KH: Read the linked article. The A6000 has an unusually high standby/sleep current. The adapter's quiescent current is not an issue, but the A6000 sleep current...
  • Drone: Jeez, the very limited DCA: 40A/400A±3.0% capability, no RMS at all, and the CAT=DEATH rating makes this a NO BUY at any price - much...
  • Drone: Back-Story... Quoting: "HydroBot is a modular control system for automating hydroponic gardens." More about it here: http://protofusion.org/wordpress/2016/07/hydrobot/ Interesting work. But I would like to see...