Categories

The LiveLight Project: open source ambilight solution

Posted on Thursday, December 15th, 2011 in code, DIY, LEDs, open source by the machinegeek
This entry was posted on Thursday, December 15th, 2011 at 6:23 pm and is filed under code, DIY, LEDs, open source. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

2 Responses to “The LiveLight Project: open source ambilight solution”

  1. dext3r says:

    very slick! i laughed at the video’s boasting of component numbers…..

    57 resistors! 10 capacitors! yowza!!!! :D

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Max: Hey, good job quoting as an abstract something the author writes about someone else's project... For the record, I do appreciate the proper attention to...
  • imqqmi: Also interesting to note that arduino's use the DTR signal to reset the device. I found this out because repetier was able to do this...
  • Kevin: A bit sad that you are using a knock off Saleae device unless you are not using Saleae software.
  • Max: For the Haxxor Edition he could add a Morse-to-scan-code translator to the code in the PIC (where the L337 Haxxor Special also accepts Unicode code...
  • KH: Someone with a PIC16F1459 project, well you don't see these every day. Methinks he repeats the USB 2.0 thing too much; this might mislead people...