Categories

IR decoding using ATtiny2313

Posted on Wednesday, June 22nd, 2011 in code, infrared by the machinegeek

This article from Radosław Kwiecień’s website shows how to decode RC5 IR signals from a remote control using the 16-bit Timer1 and INT0 external interrupt input in the ATtiny2313 Atmel AVR device.

All code in assembly in available in a compressed file.

This entry was posted on Wednesday, June 22nd, 2011 at 3:00 pm and is filed under code, infrared. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • KH: TPS62200 will get him to under 15uA, a bit better than the 20-30uA he mentioned. I would try the same thing. Switch some resistors in...
  • KH: Yeah, it's an end-user thing. Very few people would spend hundreds of hours on this kind of project and sustain it. It's more or less...
  • Max: Not quite a dinosaur if you've seen Big Hero 6 though... wait. You've watched it with your kids, didn't you? That's cheating...! ;) One of...
  • Edward Mallon: A visiting researcher dropped by our humble basement workshop with questions about the physical skill level students would need if they added one of our...
  • KH: And that looks really expensive... Only browsed the vid though, I'm an dinosaur so I had the sound off too. Nice of him to open-source...