Categories

Flat cable to header converter adapters

Posted on Tuesday, June 7th, 2011 in builds by Ian

MickM built flat cable to header converter adapters :

I was using some character LCD displays and realised that the cables were impossible to plug into the displays that I actually had.   My PCB was single row of 16, the LCD was 2×7,  no backlight.  So I made an adapter for it.

Via the forum.

This entry was posted on Tuesday, June 7th, 2011 at 6:47 am and is filed under builds. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “Flat cable to header converter adapters”

  1. Mike Donovan says:

    These are also very handy for breadboarding. Any chance of seeing these on Seeed?

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • readybrek: Anyone got a any recommendations for a budget-priced hot air station?
  • William: lol I'm happy to waste 3c for each program/debug cycle... but probably not the time spent soldering a new device down to a proto board!...
  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...