Categories

Freescale Make It Challenge

Posted on Thursday, May 5th, 2011 in Development, robotics by the machinegeek

Freescale announced their 2011 Make It Challenge!

The contest has two tracks: one for designs using the Tower System, and a second for designs with the Mechatronics Robot Platform.

In order to enter the contest, you have to register for and attend the 2011 FTF Americas conference June 20-23, 2011 in San Antonio, TX. While the registration fees for this con run around $950 (through May 27, 2011), the prizes are substantial, including $1,000, $2,000 and $3,000 prizes in each category, as well as a grand prize of a Freescale Motorsports VIP Weekend package.

Check the Freescale site for full details and contest rules.

This entry was posted on Thursday, May 5th, 2011 at 4:00 pm and is filed under Development, robotics. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please