Categories

RGB LED flower

Posted on Monday, January 10th, 2011 in AVR, LEDs, USB by jnd

RGB LED flower

This LED flower is controlled by AVR with software USB stack. It contains 6 RGB LEDs which are at the end of twisted enamelled copper wires. Project is well documented with extensive tutorial.

Via mcu.cz

This entry was posted on Monday, January 10th, 2011 at 10:30 pm and is filed under AVR, LEDs, USB. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please