Categories

VGA tester using Attiny2313

Posted on Friday, December 31st, 2010 in AVR, testing by the machinegeek

Tehnik Service presents a simple Attiny2313 project to test VGA monitors. Just the chip and a handful of discrete components are needed and the source code is provided in both assembly and a hex file, ready for download.

Via PyroElectro.

This entry was posted on Friday, December 31st, 2010 at 4:02 pm and is filed under AVR, testing. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Daniel: Do I comment here or on FB?
  • Craig B: Shouldn't the default be 00xxx010? Note that bit 0 appears out of order in the documentation. In that case I think the initial value is...
  • JJM: From the datasheet extract you are showing, the power up status should be 00xxx010, not 000xxx01. Bit numbering is misleading since 'measurement resolution' is apparently...
  • Jan Ciger (@janoc200): Hmm, that could actually explain why the three sensor IMU breakout I have bought a few years ago had all sorts of issues - I...
  • Travis: Is it preset to the windows 3 fingered salute?