Categories

MSP430 Launchpad oscilloscope

Posted on Monday, December 27th, 2010 in code, MSP430, oscilloscope by the machinegeek

NJC’s MSP430 Launchpad blog presents the LaunchScope . Using no additional hardware beyond the Launchpad, this project includes code for both the MSP430 as well as PC client display software written in C#.

This entry was posted on Monday, December 27th, 2010 at 7:24 pm and is filed under code, MSP430, oscilloscope. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “MSP430 Launchpad oscilloscope”

  1. NJC says:

    Thank you for the post! Very nicely put for the summary too.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Daniel: Do I comment here or on FB?
  • Craig B: Shouldn't the default be 00xxx010? Note that bit 0 appears out of order in the documentation. In that case I think the initial value is...
  • JJM: From the datasheet extract you are showing, the power up status should be 00xxx010, not 000xxx01. Bit numbering is misleading since 'measurement resolution' is apparently...
  • Jan Ciger (@janoc200): Hmm, that could actually explain why the three sensor IMU breakout I have bought a few years ago had all sorts of issues - I...
  • Travis: Is it preset to the windows 3 fingered salute?