Categories

STM32 ‘thinner client’ with composite video

Posted on Wednesday, October 6th, 2010 in Chips by Ian

This is a STM32 ARM-based thin client that uses a TV as an output device.

SMD projects on home-etched boards are fun to made. Don’t fear SMD, it’s cheaper, readily available, and surprisingly easy to solder with a little flux.

Via Hack a Day.

This entry was posted on Wednesday, October 6th, 2010 at 5:21 pm and is filed under Chips. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “STM32 ‘thinner client’ with composite video”

  1. zbyno brudny says:

    Did you use a Spi-port? I want to use STM32F3 for QVGA 3bpp. Videobufer will be inner STM32-Sram.
    I need advise

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Edward Mallon: Like a great Hollywood franchise, I've finally put together the prequel - months after the I2C registers tutorial was released: https://edwardmallon.wordpress.com/2017/12/17/adding-sensors-to-an-arduino-data-logger/ This adds to the...
  • Drone: So these go for around $330 USD and NO published calibration procedure online or otherwise? Given what's inside - I don't think I'll be considering...
  • Pekka Akselin: This is ridiculous!? :-) We are back at 256(!) byte EPROMs that needed multiple, a handful, of voltages to run! :-(
  • KH: Let's try a back-of-envelope calc balancing energies. From MCP1700 datasheet, there are graphs for a 200mA load step. Estimate the energy shortfall as 12uJ. Say...
  • Daniel: It's been a week and my comment is still awaiting moderation. Apparently the CIA doesn't want their involvement known?