Bus Pirate and Mac OSX tutorial

Posted on Friday, September 3rd, 2010 in Bus Pirate by Ian

Steve sent in an illustrated guide to connecting a Bus Pirate to Mac OSX (updated link). This guide is consistent with the most recent v5.x firmwares and Bus Pirate v3.

This entry was posted on Friday, September 3rd, 2010 at 7:12 am and is filed under Bus Pirate. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

2 Responses to “Bus Pirate and Mac OSX tutorial”

  1. steve says:

    the link is broken it should be:

    Unfortunately my old domain has been “jacked”, after transferring to a new hosting service, thanks “”…………

  2. rsdio says:

    Bus Pirate v4 works fine without a driver installation. Also, rather than download any of the listed third-party terminal programs, you can use ‘screen /dev/cu.usbmodem* 115200’ and it works just fine. If you have multiple USB serial devices, you might want to change the device file name appropriately.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • lostengineer: hahaha an entire article just saying to heat-shrink your wires or glue them if they might move around a lot. When did common sense die?
  • readybrek: They're tasty tasty very very tasty... they're very tasty.
  • hli: Sunday++
  • Chamod: Check on your buddy. Make sure they don't forget their lunchbox.
  • Kurt: But February made me shiver With every paper I'd deliver Bad news on the doorstep I couldn't take one more step