Skip to main content
Topic: Bus Blaster as Attachment to FT2232H Breakout Board (Read 1477 times) previous topic - next topic

Bus Blaster as Attachment to FT2232H Breakout Board

See attached image.
Not economical but I'm getting tired of waiting for the real Bus Blaster.

The .sch and .brd files aren't that clean yet but I'll post them if people deem this idea to be not completely stupid.

Re: Bus Blaster as Attachment to FT2232H Breakout Board

Reply #1
:)

Nice idea. I would go with a XC2C32A CPLD so you clone BBv2 though :) The routing should be easier.

Bus Blaster v1 will be available very shortly. It is actually ready to go in the shop today, and I am sending the sell page now. It's going to be sold at cost, and there will only be 20 of them. V2 is in production now (officially!) and will also be available in a few weeks.
Got a question? Please ask in the forum for the fastest answers.

Re: Bus Blaster as Attachment to FT2232H Breakout Board

Reply #2
I'm not that familiar with CPLDs myself. A few 7400s I can handle though.

Good to hear the news about the Bus Blaster V1, I'll be eff-fiving Seeed Studio so I don't miss it. The PCB I got them to make is ready to ship, and Ponoko already shipped my laser cut sheets. :-D