Dangerous Prototypes

Dangerous Prototypes => Bus Pirate Development => Topic started by: alby on March 06, 2021, 09:31:14 am

Title: Help bus pirate 3.6
Post by: alby on March 06, 2021, 09:31:14 am
hi everyone, i'm new and i need help, i have a 3.6 pirate bus card, and i need to read programming an atmega88.
the programming is protected, but I have read that if I install the STK500v2 signature software, perhaps I can read and save the entire programming of the cip. can someone help me.
I just have to figure out where to get the signature software and upload it to the pirate bus, hoping that it works and can read the protected cip. Thanks for your help