Skip to main content

Messages

This section allows you to view all Messages made by this member. Note that you can only see Messages made in areas you currently have access to.

Messages - yvesp123

2
#twatch network LCD backpack / Problem with my twatch when it's cold!
Hi there,

Everytime there is a significant power outage, when I turn my twatch back on, the LCD backlight blinks on and off at about 1 Hz for a few minutes.  After a while, the blinking slows down and eventually, it stops.  At that point, I need to re-adjust the contrast and reset the twatch.  Then it runs without problems for days or weeks until the next time I need to power it down (or power fails again).

That looks like a bad solder, but I don''t quite know where to start looking.  Anyone has an idea what could cause the backlight to blink on power up ?  (Maybe the unit is resetting on every blink, hard to tell since the display is unreadable, but apears to be stuck on the APIPA address, does not get to the DHCP address).

Yves
4
#twatch network LCD backpack / Re: Native Winamp plug-in for #twatch
Hi everyone,

I've worked a bit on the plug-in.  Changes include : custom char to display current playing status, new look for the progress bar, improved error condition handling (still not bullet proof but getting there), and my part for the environment, the backlight is now turned off when the playing status is stopped.

There will be a least one more update when 5.58 of Winamp comes out since they have introduced a better way of determining the status of "stop after current".

Current version number of the plug-in is 0.30 and is attached to this post.

Yves
5
#twatch network LCD backpack / Re: Native Winamp plug-in for #twatch
Ian,

Yes it is for V5.  As for open source, I'll wait till my code is cleaner ;)

I've realized that there is currently a small leak (memory or handles), since WinAmp takes longer to exit when the plugin is present.  Once that is fixed, I'll post an update.

Thanks,

Yves
6
#twatch network LCD backpack / Native Winamp plug-in for #twatch
Not to try to get in competition with anyone but...

For me, the main reason for getting a #twatch in the first place was to display the currently playing song info from WinAmp (couldn't care less about twitter:).  Since I received it, I've been working on a native plug-in for WinAmp (did not want to glue a bunch of stuff together).  So here it is, the first release.  Still fairly in beta state, but I think it might use some testing from others.  Just copy the dll in your plugin directory and it should show up in General Plugins in Winamp.  First time you lunch WinAmp, you'll get an error because the IP address in registry is not set.  Go configure the plugin with the correct IP and it should work...

In it's current state, it displays the artist name in the first row, the song title in the second, the album name and year in the third and finally, the playing status, progress bar and time (played or left) in the fourth.  It also display the shuffle state using a custom char.  If you use the modern skin, it can show the state of "Stop after current".

There are ton of stuff to be done still, like custom chars for playing status (just can't get it to work), maybe scrolling (not sure yet if it's worth the trouble on a LCD), etc...

If you don't like beta stuff, don't bother, otherwise, give it a try and let me know.

Yves
7
#twatch network LCD backpack / Re: Custom character sets
I have a similar problem.  I can reprogram character 4 always, others sometime, and others never.

My code is definitely correct since character 4 get programmed, but for any other, most of the time it doesn't work...

If anybody has a clue, it would be appreciated...

Yves