Skip to main content
Recent Posts
1
Project logs / Re: Really universal soldering controller
Last post by vulkan35 -
To the fault database:
with the connected handle without cartridge on the display blinking SENSOR OPEN -> 511C
in the calibration menu the parameter ADC floats in the interval 1023 - 1018.

the cause of the malfunction Oled 2.42" DIY MORE.

 ;)

X

4
General discussion / Backup battery Installation
Last post by jeremycc -
Hey, guys!

I want to install a backup battery in a vehicle so that I may use one battery to run the radios and other electronics all the time and not drain the primary battery.

I've looked through the forums but haven't found any information on how to achieve this.

I'd appreciate it if someone could explain how I can hook this up.
8
Project logs / Re: Really universal soldering controller
Last post by WSlomo -
I just come back to this thread after few month. I see a lot of changes: new firmware, new PCB. I suppose new 4 layer board ensure better shielding and heat dissipation but what else? Could some one in few words summarase benefits?
9
Project logs / Re: Really universal soldering controller
Last post by RCx03 -
After poking around, I'm not getting 3V3 or -0.6V from back board. Seems the LM2675 got soldered in backward, lucky the 36Vs fed to it where on an NC pin and it doesn't look damaged.