As mentioned in an earlier post
I'll try to do one small PCB project every week and then send for PCB's of it every Monday.
This week I'll be busy with other things so I'll make this weeks project very simple. In fact tt's so simple that I've already did it last week. :-) So unless someone comes up with any ideas for changes I have this "week off".
The Oledy board is a 5x5 cm board meant to be cut in half ending up with two boards 2.5 x 5 cm. Each board have a two 16-pin headers that are connected to four arrays of 32 solder pads. All eight pad arrays are of different pitch to match different OLED displays.
The piches are 0.50, 0.60, 0.62, 0.65, 0.70, 0.80, 0.845 and 1.00 mm