As mentioned in an earlier post
I'll try to do one small PCB project every week and then send for PCB's of it every Monday.
#2 was a bit late due to xmas and whatnot, but this project is so much simpler that I'm convinced that I'll be able to submit it Monday.
The PAW 3 is a "super-duper-multiple-dualsided" breakout board. Each PCB currently have 4 copies each of 6 different designs (3 designs on each side). So there's a total of 12 breakout boards with two designs each on a 5x5cm PCB.Sub-board 1
- A SOIC-16 is sharing the board with a TSSOP-16 on the back. This board also have space to put decoupling caps and LEDs/resistors on it.Sub-board 2
- A SOIC-8 is shared with a TSSOP-8 on the back.Sub-board 3
- A SOT-23-6 (small 6 pin device) is shared with 2 pcs of SOT-23 (like a transistor) on the back.
The boards will be done on a 0.8 mm pcb with "cutting grooves" made of 0.25mm wide rectangles of tStop/bStop for easier cutting with a box knife.
Any comments and/or suggestions is welcome before Monday when the order will be sent to Seeed.