Serpac box fits DP5031 with central hole?

Posted:
Tue Feb 05, 2013 1:28 pm
by t0mpr1c3
http://www.serpac.com/userprints/C4.pdfWill fit a PCB 0.063" thick x 1.96" x 1.21" (in Liberian/Burmese units) = 1.6 x 50.5 x 30.7 mm
Only problem is the central screw fixing.
Re: Serpac box fits DP5031 with central hole?

Posted:
Wed Feb 06, 2013 6:39 am
by ian
Central screw hole could be done with a big via or something, I guess just put it on the center point cross hairs on the SoC template.
they have multiple box colors

Posted:
Wed Feb 27, 2013 2:17 pm
by kenyee
FYI, they also have black and translucent colors for their other cases.
Biggest problem with these cases is if you have any connectors at all or even a coin cell holder, your board no longer fits unless you cut out big chunks of the case...