Page 1 of 1

SoB standoff nut/screw sizes?

PostPosted: Tue Jan 08, 2013 5:11 pm
by kenyee
Anyone know what the specs on the nuts/screws are? Finally got my order of a few of these from Seeed and it looks like it might be fine if all you use is surface mount stuff, but if you have any other components like a coin cell batter holder, stereo jacks, etc., there's no way it'll fit properly w/o higher standoffs and longer screws...

Re: SoB standoff nut/screw sizes?

PostPosted: Wed Jan 09, 2013 3:11 am
by arakis
They are all M3 hex standard. The holes are 3.2mm in diameter and the keep-out area is 6mm in diameter.
http://icrank.com/cgi-bin/data/metric_s ... c_beta.cgi