SoB standoff nut/screw sizes?

Standard PCB templates and project cases

SoB standoff nut/screw sizes?

Postby kenyee » Tue Jan 08, 2013 5:11 pm

Anyone know what the specs on the nuts/screws are? Finally got my order of a few of these from Seeed and it looks like it might be fine if all you use is surface mount stuff, but if you have any other components like a coin cell batter holder, stereo jacks, etc., there's no way it'll fit properly w/o higher standoffs and longer screws...
Posts: 48
Joined: Tue May 22, 2012 9:26 am

Re: SoB standoff nut/screw sizes?

Postby arakis » Wed Jan 09, 2013 3:11 am

They are all M3 hex standard. The holes are 3.2mm in diameter and the keep-out area is 6mm in diameter. ... c_beta.cgi
best regards FIlip.
Posts: 1044
Joined: Wed May 25, 2011 11:15 am
Location: Belgrade, Serbia

Return to Sick of Beige