Bus Blaster and Atmel EEPLD!!

High-speed USB 2.0 JTAG debugger and flash programmer. V2 available now for $34.95.

Bus Blaster and Atmel EEPLD!!

Postby jamicankones » Sun Jun 30, 2019 9:09 am

I was wondering if it is possible to use the Bus Blaster to program, read, verify Atmel EEPLD devices. I have several of the ATF1508AS, ATF1504, and ATF1502, it is these devices I would like to keep using. I was programming them with a very ancient Windows 98 machine using Atmel's software (provided with a development kit) to program these. The devices do program/verify using a JTAG interface. But they are 5 volt devices, and I see the Bus Blaster is 3.3 volt. I was just wondering. It might save me some reverse engineering. The ancient Windows 98 machine has stopped working. I needed this old machine because my current programmer (form the Atmel development kit) uses a parallel port interface. I doubt that one could get this parallel port working on a current x86 machine under Windows 7. As I thing it used direct port access, a big no-no in the current OSes available. I was just wondering.
jamicankones
Newbie
Newbie
 
Posts: 1
Joined: Sun Jun 30, 2019 9:08 am

Return to Bus Blaster JTAG debugger